Fiberglass sleeving is often used in many different types of electrical products. It is used to insulate from heat. It is used to hold wires together. It is used to cover splices. It comes in different materials for different applications.
It is important to know there are difference types of sleeving and although it says UR, it may be the wrong UR category. There are two main categories UL Recognizes Sleeving under – Flame Retardant and Coated Electrical. The last thing you want to do is pick the wrong one, order 100,000 feet of it, go into production only to find out 2 weeks before shipping it is UR in the wrong category.
UZIQ2.GuideInfo - Sleeving, Flame Retardant – Component
CONDITIONS OF ACCEPTABILITY
Consideration is to be given to the following Conditions of Acceptability when these components are employed in the end-use equipment:
1. This sleeving has not been investigated for any electrical or mechanical capabilities.
2. This sleeving has not been investigated to determine its thermal performance.
3. This sleeving has not been investigated for use in contact with sharp edges, corners, projections or burrs, or where subject to tension, compression, abrasion, repeated flexing or where exposed to ultraviolet radiation or oil contamination.
UZFT2.GuideInfo - Sleeving, Coated Electrical - Component
CONDITIONS OF ACCEPTABILITY
Consideration is to be given to the following Conditions of Acceptability when these components are employed in the end-use equipment:
1. Sleeving shall not be used over the maximum voltage rating.
2. Sleeving shall not be used over the maximum temperature rating.
3. The minimum wall thickness of the sleeving shall comply with the requirements of the end product.
4. Sleeving marked "Oil Resistant 60°C " or "Oil Resistant 80°C" has been investigated for intermittent or occasional contact with oil not exceeding the oil rating.
5. Sleeving marked "VW-1" has been investigated using a fine wire support in conducting the flammability test.
6. Sleeving is not acceptable for use in contact with sharp edges, corners, projections or burrs , or where subjected to tension, compression, abrasion or repeated flexing without additional testing.
7. Sleeving is not recommended for use where it is feasible to employ a standard insulated conductor (appliance wiring material) intended for the purpose.
8. Sleeving shall be used in dry and damp locations only as defined in ANSI/NFPA 70, "National Electrical Code."
Most of our discussions with clients begin like this: “I need to get a UL mark on my product, but it should be pretty easy because all of the major components have a UL mark…”, or “I’ve got almost the exact same product as this one with an ETL mark, so I don’t need to do any testing…”
Our 25 years of experience in testing has shown us that 9-out-of-10 products fail the first time they undergo testing. We can help you avoid many testing problems, and find solutions for whatever noncompliance issues might arise.